![Marlin firmware for mac](https://kumkoniak.com/16.jpg)
So I conneted, uploaded teh firmware 2.02, approved the installation and the last step determined that the board was not configured. I was able to upload the file confirm the installation the board downloaded the information and at the end the message was that the device was not configured. What happened when you tried to update to 2.02? Once I got a USB port given by the nework scan, and then went to screen the board to get the firmware version and the ISP and firmeware version never appeared, the message was that the device was not configured. I have tried pinging the IP several ways, but the process prescribed by the Duet instructions does not provide an IP. If you connect it back up to the printer do any lights come on?Īll of the requisite lights come on the red communication lights for the USB, the network lights, the blue light, all of the lights come on. The cables I a using are new and worked BEFORE the firmware installation Have you tried different USB ports or micro USB cables? It does not appear on any device communication suite, neither Pronterface nor Arduino IDE, it does not appear on the port manager in arduino, although it did initially, then stopped doing so. If you plug it into USB do any lights come on? It's not clear from your description what state your board is actually in and what you've tried. Said in How did the firmware update evaporate from my board?:
![Marlin firmware for mac](https://kumkoniak.com/16.jpg)